The equipment heating and temperature control for hot stamping of stainless steel and high-alloyed

The equipment heating and temperature control for hot stamping of stainless steel and high-alloyed

Press-forging equipment company «CARLO SALVI» allows stamping parts and pieces of stainless steels and high traditionally difficult to manufacture. For this purpose a preheating of the workpiece in a special inductor providing a temperature range of 200 to 500 ° C. Using the pre-heating the workpiece before planting allows us to solve many technological problems, which sometimes can not be solved by cold forming.

Additional equipment for induction heating of blanks used for hot stamping parts and pieces of stainless and high-alloy steels, and can be installed on any model of presses manufactured by «CARLO SALVI».

The equipment is supplied complete with a thermal control system that ensures constant and repeatable wire heating conditions as in the external parameters, such as initial temperature of the wire, and when changing process parameters such as feed rate.

For temperature control using digital pyrometers.

On and off the inductor is done automatically when you turn on and off the press, and power is controlled from the control parameters of the inductor.

The cooling system of induction heating is optional. The cooling system provides optimal conditions for the electronics control and stability of the inducer, although not mandatory system, part of a common set of induction heating system. Cooling System -prinuditelnaya, gas.

Electronic pyrometers are installed in the press housing in the installation of an induction heater in parallel to the supply wire rod.

Control system for billet heating temperature, the data from the electronic thermometer, commutes control signal to the electronic control system of the press and the heating control system. This allows the best way to configure the operation of the press for maximum performance.

SQL - 17 | 0,418 сек. | 7.4 МБ